Enail Instructions

1. Clear off your set up space.

2. Set your enail controller box on a flat surface.

3. Connect the power cord to the enail controller box and plug the controller box power cord into a nearby outlet.

• You should never plug an enail controller box into a power strip, it should be directly plugged into a wall outlet.
• If there are a lot of items plugged in and operating while your enail is plugged in, depending on how old your house is, operating an enail may trip the circuit breakers.
• If the circuit breakers trip, please examine your enail coil for any faulty wiring or any wires that may be sticking out of the sleeve, this may be the cause.
• Do not turn the controller box on before the heater coil is plugged into the controller box, if you turn the controller box on before the coil is connected your display screen will read an error code.

4. After the controller box is plugged in, plug in the enail coil heater in its designated place.

5. Then properly secure the enail coil to the nail/banger with its appropriate dish, clips, clamps, or hangers.

6. Connect the nail/banger to your preferred dab rig which is already filled with a suitable amount of water.

• When choosing a dab rig, go for something that is a little larger in size or something with a sturdy base.
• If the dab rig being used with your enail is too small or lightweight it may tip over because of the added weight of the coil and the nail/banger.

7. The controller box can now be turned on, most enail controller boxes will have a switch or a button to turn it on and off.

• If you see an error code on the display screen after the controller box is turned on and the COIL IS CONNECTED PROPERLY, this may indicate that there is a problem with the coil’s thermocouple. This does NOT mean the unit is faulty.

8. Set the controller box to your desired temperature by pressing the arrow buttons up or down, after the display shows your desired temperature, please hold the power button for a couple of seconds and then the coil will start to heat.

• Do not press the M button to set the temperature, the M button stands for settings. Which will assist you in switching your controller box from fahrenheit to celsius, etc.
• We do not recommend running your enail controller any higher than 650 degrees Fahrenheit, running an enail controller at extremely high temperatures can break or crack your banger.
• Running an enail at super high temps is counterproductive to your concentrate consumption, this will burn through your concentrates instead of vaporizing them which is exceedingly wasteful.
• When setting the temp on a controller box higher than 650 degrees you run the risk of burning large amounts of residue onto your nail/banger which is almost impossible to clean off.

10. Once the banger/nail is to your desired temperature (usually takes about 60 seconds to heat, the banger should reach temperature about 120 seconds after that), pick up the desired amount of concentrates with the tip of a dab tool.

11. Place the concentrates on the bottom of the heated surface with the dab tool.

12. Inhale through the dab rig mouthpiece.